| Inspection Type |
Planned
|
| Scope |
Partial
|
| Safety/Health |
Safety
|
| Close Conference |
2021-04-22
|
| Emphasis |
L: LOCALTARG, P: LOCALTARG
|
| Case Closed |
2022-04-07
|
Violation Items
| Citation ID |
01001 |
| Citaton Type |
Serious |
| Standard Cited |
19260403 B02 |
| Issuance Date |
2021-10-20 |
| Abatement Due Date |
2021-11-01 |
| Current Penalty |
1610.0 |
| Initial Penalty |
2341.0 |
| Final Order |
2022-04-07 |
| Nr Instances |
1 |
| Nr Exposed |
3 |
| Gravity |
5 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1926.403(b)(2):Listed, labeled, or certified equipment was not installed and used in accordance with instructions included in the listing, labeling, or certification: Location: 1471 East 10th Street, Brooklyn, NY 11230On or about: April 22, 2021 (a) The employer did not ensure that equipment was used in accordance to the instructions on the listing and labeling; employees used an extension cord not listed for construction settings. |
|
| Citation ID |
01002 |
| Citaton Type |
Serious |
| Standard Cited |
19260404 F06 |
| Issuance Date |
2021-10-20 |
| Abatement Due Date |
2021-11-01 |
| Current Penalty |
1610.0 |
| Initial Penalty |
2341.0 |
| Final Order |
2022-04-07 |
| Nr Instances |
1 |
| Nr Exposed |
3 |
| Gravity |
5 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1926.404(f)(6):The path to ground from circuits, equipment, or enclosures was not permanent and continuous: Location: 1471 East 10th Street, Brooklyn, NY 11230 - First floor On or about: April 22, 2021 (a) The electrical cord used to energize the Skilsaw was missing the ground pin. (b) A three prong extension cord was plugged into a two prong receptacle. |
|
| Citation ID |
01003 |
| Citaton Type |
Serious |
| Standard Cited |
19260405 G02 IV |
| Issuance Date |
2021-10-20 |
| Abatement Due Date |
2021-11-01 |
| Current Penalty |
1610.0 |
| Initial Penalty |
2341.0 |
| Final Order |
2022-04-07 |
| Nr Instances |
1 |
| Nr Exposed |
1 |
| Gravity |
5 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1926.405(g)(2)(iv):Flexible cords were not connected to devices and fittings so that strain relief is provided to prevent pull from being directly transmitted to joints or terminal screws: Location: 1471 East 10th Street, Brooklyn, NY 11230 On or about: April 22, 2021 (a) The employer did not ensure that strain relief was provide to the flexible cord used to energize the Skilsaw; the extension cord had strain damage exposing the internal wire insulation. |
|
| Citation ID |
01004 |
| Citaton Type |
Serious |
| Standard Cited |
19260501 B14 |
| Issuance Date |
2021-10-20 |
| Abatement Due Date |
2021-11-01 |
| Current Penalty |
2870.0 |
| Initial Penalty |
4096.0 |
| Final Order |
2022-04-07 |
| Nr Instances |
1 |
| Nr Exposed |
3 |
| Gravity |
10 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1926.501(b)(14): Each employee working on, at, above, or near wall openings (including those with chutes attached), where the outside bottom edge of the wall opening was 6 feet (1.8 m) or more above lower levels and the inside bottom edge of the wall opening is less than 39 inches (1.0 M) above the walking/working surface, is not protected from falling by the use of a guardrail system, a safety net system, or a personal fall arrest system. Location: 1471 East 10th Street, Brooklyn, NY 11230 On or about: April 22, 2021 (a) Employees were not protected from falling through a wall opening on the second floor; employees were exposed to falling approximately 10 feet to lower levels. |
|
|
