| Inspection Type |
Complaint
|
| Scope |
Partial
|
| Safety/Health |
Safety
|
| Close Conference |
2015-04-02
|
| Case Closed |
2018-12-18
|
Related Activity
| Type |
Complaint |
| Activity Nr |
972756 |
| Safety |
Yes |
|
Violation Items
| Citation ID |
01001 |
| Citaton Type |
Serious |
| Standard Cited |
19100022 A02 |
| Issuance Date |
2015-05-19 |
| Abatement Due Date |
2015-06-01 |
| Current Penalty |
1260.0 |
| Initial Penalty |
2100.0 |
| Final Order |
2015-06-09 |
| Nr Instances |
2 |
| Nr Exposed |
8 |
| Gravity |
1 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1910.22(a)(2): Floor(s) of workroom(s) were not maintained in a clean and, so far as possible, a dry condition: a) At the establishment, on or about 4/2/2015, floors were continuously wet and slippery due to multiple roof leaks, in the areas listed: storage area, sales floor, deli, and bakery. b) At the bakery, on or about 4/2/2015, floors were continuously wet and slippery due to a leak off the hand washing sink. |
|
| Citation ID |
01002 |
| Citaton Type |
Serious |
| Standard Cited |
19100147 C01 |
| Issuance Date |
2015-05-19 |
| Abatement Due Date |
2015-06-15 |
| Current Penalty |
2940.0 |
| Initial Penalty |
4900.0 |
| Final Order |
2015-06-09 |
| Nr Instances |
4 |
| Nr Exposed |
7 |
| Gravity |
10 |
| FTA Inspection NR |
1093106 |
| FTA Issuance Date |
2015-12-30 |
| FTA Current Penalty |
1000.0 |
| FTA Contest Date |
2016-01-21 |
| FTA Final Order Date |
2016-05-31 |
| Citation text line |
29 CFR 1910.147(c)(1): The employer did not establish a program consisting of an energy control procedure, employee training and periodic inspections to ensure that before any employee performed any servicing or maintenance on a machine or equipment where the unexpected energizing, startup or release of stored energy could occur and cause injury, the machine or equipment shall be isolated from the energy source and rendered inoperative: a) At the bakery, on or about 4/2/2015, employees set up for use and cleaned a Hobart Dough Mixer, Model M802, without isolating the source of energy in case of unexpected startup. b) At the bakery, on or about 4/2/2015, employees cleaned a Hobart Dough Mixer, Model A200, without isolating the source of energy in case of unexpected startup. c) At the deli, on or about 4/2/2015, employees set up for use and cleaned a Bizerba Slicer, S/N 126 2435, without isolating the source of energy in case of unexpected startup. d) At the deli, on or about 4/2/2015, employees set up for use and cleaned a Bizerba Slicer, S/N 203 4068, without isolating the source of energy in case of unexpected startup. |
|
| Citation ID |
01003A |
| Citaton Type |
Serious |
| Standard Cited |
19100212 A03 II |
| Issuance Date |
2015-05-19 |
| Abatement Due Date |
2015-06-15 |
| Current Penalty |
2940.0 |
| Initial Penalty |
4900.0 |
| Final Order |
2015-06-09 |
| Nr Instances |
2 |
| Nr Exposed |
3 |
| Gravity |
10 |
| FTA Inspection NR |
1093106 |
| FTA Issuance Date |
2015-12-30 |
| FTA Current Penalty |
1000.0 |
| FTA Contest Date |
2016-01-21 |
| FTA Final Order Date |
2016-05-31 |
| Citation text line |
29 CFR 1910.212(a)(3)(ii): Point(s) of operation of machinery were not guarded to prevent employee(s) from having any part of their body in the danger zone(s) during operating cycle(s): a) At the bakery, on or about 4/2/2015, employees operated an unguarded Hobart Dough Mixer, Model M802 b) At the bakery, on or about 4/2/2015, employees operated an unguarded Hobart Dough Mixer, Model A200 |
|
| Citation ID |
01003B |
| Citaton Type |
Serious |
| Standard Cited |
19100263 E02 I |
| Issuance Date |
2015-05-19 |
| Abatement Due Date |
2015-08-01 |
| Current Penalty |
0.0 |
| Initial Penalty |
0.0 |
| Final Order |
2015-06-09 |
| Nr Instances |
2 |
| Nr Exposed |
3 |
| Gravity |
5 |
| FTA Inspection NR |
1093106 |
| FTA Issuance Date |
2015-12-30 |
| FTA Current Penalty |
0.0 |
| FTA Contest Date |
2016-01-21 |
| FTA Final Order Date |
2016-05-31 |
| Citation text line |
29 CFR 1910.263(e)(2)(i): Vertical mixers did not comply with paragraph (e)(1)(i) and did not have moving parts completely enclosed: a) At the bakery, on or about 4/2/2015, employees operated an unguarded Hobart Dough Mixer, Model M802 b) At the bakery, on or about 4/2/2015, employees operated an unguarded Hobart Dough Mixer, Model A200 |
|
| Citation ID |
01004A |
| Citaton Type |
Serious |
| Standard Cited |
19100303 F02 |
| Issuance Date |
2015-05-19 |
| Abatement Due Date |
2015-06-15 |
| Current Penalty |
2100.0 |
| Initial Penalty |
3500.0 |
| Final Order |
2015-06-09 |
| Nr Instances |
2 |
| Nr Exposed |
9 |
| Gravity |
5 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1910.303(f)(2): Services, feeders, and branch circuits. Each service, feeder, and branch circuit, at its disconnecting means or overcurrent device, shall be legibly marked to indicate its purpose, unless located and arranged so the purpose is evident. a) At the bakery, on or about 4/2/2015: the electrical panel box was not labeled properly; breaker #8 is used to de-energize ceiling light fixtures in the deli, but on the panel label it is listed as breaker #18 b) At the bakery, on or about 4/2/2015: the electrical panel box was not labeled properly; breaker #28, 30, 32 are listed as Mixer, but neither specifies which mixer it de-energizes; there are three mixers in the bakery |
|
| Citation ID |
01004B |
| Citaton Type |
Serious |
| Standard Cited |
19100303 G01 I A |
| Issuance Date |
2015-05-19 |
| Current Penalty |
0.0 |
| Initial Penalty |
0.0 |
| Final Order |
2015-06-09 |
| Nr Instances |
1 |
| Nr Exposed |
50 |
| Gravity |
1 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1910.303(g)(1)(i)(A): The depth of the working space in the direction of access to live parts may not be less than indicated in Table S-1. Distances shall be measured from the live parts if they are exposed or from the enclosure front or opening if they are enclosed; a) At the storage area, on or about 4/2/2015: electrical breaker panels were obstructed by excess materials |
|
| Citation ID |
01004C |
| Citaton Type |
Serious |
| Standard Cited |
19100303 G02 I |
| Issuance Date |
2015-05-19 |
| Abatement Due Date |
2015-06-15 |
| Current Penalty |
0.0 |
| Initial Penalty |
0.0 |
| Final Order |
2015-06-09 |
| Nr Instances |
1 |
| Nr Exposed |
50 |
| Gravity |
5 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1910.303(g)(2)(i): Except as elsewhere required or permitted by this standard, live parts of electric equipment operating at 50 volts or more shall be guarded against accidental contact by use of approved cabinets or other forms of approved enclosures or by any of the following means: a) At the warehouse, on or about 4/2/2015: the faceplate on an Intermatic Time Switch did not fully enclose electrical live parts. |
|
| Citation ID |
02001A |
| Citaton Type |
Other |
| Standard Cited |
19040004 A |
| Issuance Date |
2015-05-19 |
| Abatement Due Date |
2015-06-15 |
| Current Penalty |
420.0 |
| Initial Penalty |
700.0 |
| Final Order |
2015-06-09 |
| Nr Instances |
1 |
| Nr Exposed |
50 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1904.4(a): The employer did not record each work-related fatality, injury or illness case that resulted in the general recording criteria on the OSHA Form 300 or equivalent. a) At 611 East Main Street, Palmyra, N.Y., on or about 4/3/2015, the employer did not record the following workplace injuries or illnesses on the OSHA Form 300 or equivalent for the calendar year 2014: - knee injury on 2/26/2015 - a cut on the ring finger to the nail bed on 12/20/2014 - a cut the right middle finger on 12/15/2014 - an injury to the left shoulder on 10/8/2014 |
|
| Citation ID |
02001B |
| Citaton Type |
Other |
| Standard Cited |
19040032 A02 |
| Issuance Date |
2015-05-19 |
| Abatement Due Date |
2015-06-15 |
| Current Penalty |
0.0 |
| Initial Penalty |
0.0 |
| Final Order |
2015-06-09 |
| Nr Instances |
1 |
| Nr Exposed |
50 |
| FTA Current Penalty |
0.0 |
| Citation text line |
29 CFR 1904.32(a)(2): 29 CFR 1904.32(a)(2): The Summary of Work-Related Injuries and Illnesses (OSHAForm 300A or equivalent) was not created, certified, nor posted: a) At 611 East Main Street, Palmyra, N.Y.: On or about 4/3/2015, the employer had not created or verified injury and illness logs, nor posted from 2/1/2015 to 4/30/2015 a Summary of Work Related Injuries and Illnesses Log (OSHA-300A) for the previous year |
|
|
